Auto Dynasty C- 0040 Running Boards Installation Guide

Auto Dynasty C- 0040 Running Boards  

Tools Required

• 16mm, 13mm Socket
• Ratchet
• Torque Wrench

Notes

• Read this instruction carefully before starting installation.
• Proper tools will improve the quality of installation and reduce the time required.
• If missing parts or any damage found, please take a picture, and contact us.

CARE AND USE INSTRUCTIONS

Step 1:

1. Locate (3) mounting positions on each side inner rocker panel.
2. There are 4 mounting positions each side, we will use the Ist, 2nd, 4th.

Step 2:

1. Insert M10 clip nuts onto existing holes on inner rocker panel.
2. Attach bracket onto inner rocker panel and secure with (2) M10 hex bolts,(2) M10 flat washers, (2) M10 lock washers.
3. Secure bracket onto pinch weld with (2) M10 hex botls, (4) M10 flat washers,(2) M10 lock washers, (2) M10 hex nuts.

On some vehicles the mounting holes do not line up with the factory hole. In this case drill out the holes using a 7/16″ drill bit.

Step 3:

1. Remove (6) M8 hex bolts and (6) M8 flat washers under the step bar.
2. Slide mounting tracks to proper positions.
3. With assistance, lift and attach the step bar to brackets. Secure the step bar on brackets using (6) M8 hex bolts and (6) M8 flat washers.
4. Repeat to install the other side step bar.

Step 4:

1. Tighten M10 hex bolts and nuts on vehicle with 30 ft. Ibs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. Ibs. torque.
3. After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.

Part List

FAQs